C17 Fuselarge part 2
I have printed mojority of the fuselarge but it keeps failing on the over hang, is there a way to add support to hold that section in place, then cut it out with snips, while remaining in spiral vase mode.
Thanks
Matt
top of page
C17 Fuselarge F2 Failure
C17 Fuselarge F2 Failure
5 ответов0 комментариев
Лайк
5 комментариев
Комментарии к этому посту больше не доступны. Обратитесь к владельцу сайта за дополнительной информацией.
bottom of page
Hello,
Starting my print journey with this. Got F1 printed and came out great. F2 has this that seems its just missing a layer. Is this what yall are talking about that might be causing the issue? If so, as anyone gotten a fix? Thanks!