My wing joint is very loose. I can move the wing side to side and there are several mm of movement in the rear connection. If I hold the wing and jiggle the fuselage, the tail moves at least 5cm. I would not trust this one bit for the maiden. Anyone have this issue? No response from Troy.
top of page
Bunun nasıl çalıştığını görmek için sitenizi yayınlayın ve canlı sitenize gidin.
4 Yorum
Bu gönderiye yorum yapmak artık mümkün değil. Daha fazla bilgi için site sahibiyle iletişime geçin.
bottom of page
This is what I’m going to try, a little play-doh in the rear joint to fill the slop and 2 pins in the front joint to keep the wing from sliding forward and loosening the rear connection.
It’s apparent that Troy isn’t as honorable as I thought since he hasn’t replied to anybody’s comments. I couldn’t get the correct wedges carved out. I am currently re-printing portions of each section so I can attempt filling the joint with silicone to try and achieve a good filler piece.
Hi, yes I have exactly the same issue and would like a response or a fix .