Downloaded purchased 170 file, but when I use the stl it does not slice fuselage cowl or the Fuselage correctly. The nose cowl detail in front opening not there, just an open hole. Same with the fuselage front opening, just a hole no structure. what am i doing wrong, used a Bambu A1mini for cowl and Prusa Mk4s for the fuselage. I do see a ghost image of the missing structure pre slice, but disappears when sliced?
top of page
Bunun nasıl çalıştığını görmek için sitenizi yayınlayın ve canlı sitenize gidin.
2 Yorum
Bu gönderiye yorum yapmak artık mümkün değil. Daha fazla bilgi için site sahibiyle iletişime geçin.
bottom of page
The two stl files you mentioned (fuselage and fuselage cowl) show up as "unclosed meshes" when inserted into Fusion. These are the only two that seem to have a minor issue. They sliced OK (Cura 5.8) and also printed fine though.
Figured it out, for my Mk4s settings "Advanced" under "Slicing" changed my "Slice Gap Closing Radius" to 0.001 from default of 0.049. Also "Slicing Mode", changed to either Even-Odd or Close Holes, finally settled with Even-Odd for Prusa auto suggested Even-Odd for 3DLabprint Airplanes