I have problems laminating the 321 airliner plane. I have an Anycubic Kobra S1 printer that uses the Orca laminator, but the plane has Cura laminator settings. Can you help me because the Orca laminator is not the same as the Cura one and when I put in, for example, the 4th layer of the lower fuselage, the entire piece becomes solid from below. How can I solve this?top of page
For å se hvordan dette fungerer går du til livesiden din.
different licking
different licking
0 kommentarer
Comments (0)
Det er ikke lenger mulig å kommentere dette innlegget. Kontakt nettstedseieren for mer informasjon.
bottom of page